- 12%

Non-Programmable Thermostat for Home Single-Stage Systems, 1 Heat/1 Cool, Easy DIY Install, Blue Backlight

Original price was: $25.99.Current price is: $22.99.

Added to wishlistRemoved from wishlist 0
Add to compare


Price: $25.99 - $22.99
(as of Jan 15, 2025 10:40:29 UTC – Details)

Product Description

STN601-Blue

STN601-BlueSTN601-Blue

STN601-BlueSTN601-Blue

STN601-BlueSTN601-Blue

STN601-BlueSTN601-Blue

STN601-BlueSTN601-Blue

STN601-Blue

Simple thermostat for home,room temperature controller,temperature regulator for heating and cooling,house furnace,gas fireplaces,AC unit,millivolt control panel,temperature switch,non programmable thermostat,push button wall thermostat DIY,hvac fan

High Compatibility: Forced air (gas, oil or electric), Electric furnace, Hot water steam or gravity radiant heat, Heat only systems, Heat pump w/o auxiliary or emergency heat, Millivolt, Gas fireplaces (24V), Floor or wall furnaces, Cool only systems.(TIP: Before purchasing, check to see if this thermostat is compatible with your system.)
Not Compatible: Heat pump with auxiliary or emergency heat, Dual fuel/hybrid heating, Electric baseboard heat (110-240 volts), Line voltage, Convectors, Radiant-ceiling heat, Mini split systems and 12V RV systems.
Easy to Install and Use: Large terminal blocks with universal sub-base, can be installed within 30 minutes, clear, easy-to-read backlight LCD display and easy controls make for a user-friendly experience.
Simple but Powerful Control: Easy-access front-load battery compartment, adjustable temperature differential (swing) for energy optimization and maximum system life, Support temperature display calibration, Convert °C/°F units, compressor delay protection (selectable on or off).
Dual Power Supply: Can be powered by 24VAC power or 2 AAA batteries, No common wire (C-wire) required on most systems (only required on heat only and cool only systems).

Customers say

Customers find the thermostat easy to install and use. They appreciate its simple wiring, operation, and good build quality. The display is large and clear, with a backlight that helps viewing.

AI-generated from the text of customer reviews

9 reviews for Non-Programmable Thermostat for Home Single-Stage Systems, 1 Heat/1 Cool, Easy DIY Install, Blue Backlight

0.0 out of 5
★★★★★
0
★★★★★
0
★★★★★
0
★★★★★
0
★★★★★
0
Write a review
Show all Most Helpful Highest Rating Lowest Rating
  1. Leigh P. –

    Just works!
    Simple connection and operation. If you don’t need programming the temp this may be it. Display is bright and responsive. 2 Standard AAA batteries with easy access on the front. Well done

    Helpful(0) Unhelpful(0)You have already voted this
  2. Dockmaster –

    Easy installation. Large, easy to read display.
    Good product. Fast shipping. I like the large display that shows room temp, set temp, and status simultaneously. Essy batter access.

    Helpful(0) Unhelpful(0)You have already voted this
  3. Troy D. –

    Lots of fine tuning built into this thermostat
    Despite the literature saying this would not work with a 12 Volt system, I can confirm it works fine with my Dometic 18,000 BTU 12 Volt Furnace in my RV. There is a – 4 + 4 temperature compensation, as well as a “swing level” (Temperature differential setting) Which is extremely handy for small vehicles like RVs. This makes the furnace run or cycle a little more frequently, but it evens out the extreme high and low temperatures. I’ve been wanting this feature for a while, but no other thermostat I have used has this feature.The thermometer on the thermostat is a little slow in responsiveness and the overall finish has a very cheap feel to it, but I do like its features, again, particularly well suited for an RV.I also like you can access the batteries from the front. Numbers are sufficiently large for easy reading, but It’s still a bit difficult to read in dim lighting. You just about need to press the display to turn on the backlit illumination if you want to clearly read the display. The backlight is very nice for viewing, but it turns off pretty quickly to conserve power.I’m using it for a heat-only system so I cannot comment about the fan or cooling aspects of this thermostat or compatibility with heat pumps etc. For an RV I would say it works well, with particularly well-suited features.I have tested this against multiple Honeywell models and Emerson thermostats (White Rogers) and it beat them both. For the price, I think it represents a great value. 1 star removed for build quality, 5 stars for features.

    Helpful(0) Unhelpful(0)You have already voted this
  4. Kelli Charkosky –

    Easy install
    Easy fast installation works like a charm!!!

    Helpful(0) Unhelpful(0)You have already voted this
  5. Andrea –

    Thermostat
    Great size easy to read, assemble, good quality

    Helpful(0) Unhelpful(0)You have already voted this
  6. Martin Saltzman –

    Better than my last Honeywell which was 3 times the price
    Good instructions

    Helpful(0) Unhelpful(0)You have already voted this
  7. Kenneth.Whitaker –

    Nice product
    Works well

    Helpful(0) Unhelpful(0)You have already voted this
  8. jeff rothmeyer –

    Inexpensive
    Thermometer is off about 2deg but works like the big display and light

    Helpful(0) Unhelpful(0)You have already voted this
  9. Jack Howton –

    works great

    Helpful(0) Unhelpful(0)You have already voted this

    Add a review

    Your email address will not be published. Required fields are marked *

    Non-Programmable Thermostat for Home Single-Stage Systems, 1 Heat/1 Cool, Easy DIY Install, Blue Backlight
    Non-Programmable Thermostat for Home Single-Stage Systems, 1 Heat/1 Cool, Easy DIY Install, Blue Backlight

    Original price was: $25.99.Current price is: $22.99.

    Best Deals for all new
    Logo
    Compare items
    • Total (0)
    Compare
    0
    Shopping cart